Dodge Charger Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
Ok so far I've been able to get all of the stock parts off (cats and headers) but I'm starting to have trouble with the new kooks install. I'm having a hard time getting the new ones to align to get the bolts in. The first bolts on either side of the engine (closest to front bumper) are not lining up as well as every other bolt when bolting there headers on. I've tried taking them off and realigning them twice but keep getting the sameresult.. any words of advice would help a lot
 

·
Registered
Joined
·
142 Posts
If you have not done this already try this. Start the front one first but don't tighten it down, then do the same with the rest, only tighten them down when all are started. If that wont work you may need to drill the hole a little larger on those two. I have put headers on a lot of cars, but only on ones I was racing. Not worth the trouble on a street car, they are a pain in the ass to install.
 
1 - 2 of 2 Posts
Top